Knowledgebase
How do I set up my VOIPo Linksys PAP2-T Phone Adapter?
Posted by - NA - on 13 November 2008 08:21 AM

Before setting up your VOIPo service, make sure that you have received the following three (3) items in your package as they are necessary for set up:

    1. Linksys PAP2-T Phone Adapter pre-configured for VOIPo
    2. Ethernet Cable
    3. A/C Power Adapter

Installation of the device takes approximately 5 minutes to complete. Follow these four (4) easy steps to get your VOIPo up and running:

Step 1: First, be sure to unplug your modem and router from their respective power sources before setting up your Linksys phone adapter.

Step 2: Take the Linksys adapter out and then plug the telephone cable from your house phone into the adapter (Phone 1). Note that only touch tone phones are currently supported.

Step 3: Plug your Ethernet cable from your router into the Linksys port labeled Internet.

Step 4: Finally, plug back in your modem and router, plug the A/C Power Adapter into the correct port on the back of the Linksys adapter, and wait until the Power, Internet, Phone 2, and Phone 1 lights all turn on solid green.

Congratulations, you are now ready to use your VOIPo phone! If you have any questions please contact support toll free at 877.99.VOIPO or via email at support@voipo.com

(413 vote(s))
Helpful
Not helpful

Comments (0)